Abstract

Active prosthetic and orthotic devices have the potential to increase quality of life for individuals with impaired mobility. However, more research into human-like control methods is needed to create seamless interaction between device and user. In forward simulations the reflex-based neuromuscular model (RNM) by Song and Geyer shows promising similarities with real human gait in unperturbed conditions. The goal of this work was to validate and, if needed, extend the RNM to reproduce human kinematics and kinetics during walking in unperturbed and perturbed conditions. The RNM was optimized to reproduce joint torque, calculated with inverse dynamics, from kinematic and force data of unperturbed and perturbed treadmill walking of able-bodied human subjects. Torques generated by the RNM matched closely with torques found from inverse dynamics analysis on human data for unperturbed walking. However, for perturbed walking the modulation of the ankle torque in the RNM was opposite to the modulation observed in humans. Therefore, the RNM was extended with a control module that activates and inhibits muscles around the ankle of the stance leg, based on changes in whole body center of mass velocity. The added module improves the ability of the RNM to replicate human ankle torque response in response to perturbations. This reflex-based neuromuscular model with whole body center of mass velocity feedback can reproduce gait kinetics of unperturbed and perturbed gait, and as such holds promise as a basis for advanced controllers of prosthetic and orthotic devices.

Highlights

  • Active and portable prosthetic and orthotic (P/O) devices for the lower extremities have the potential to improve mobility and quality of life for individuals with reduced mobility [1], [2]

  • Model torque data from three versions of the reflex-based neuromuscular model (RNM) was compared with able-bodied human torque data, obtained through inverse dynamics methods, from experiments in which subjects were perturbed during treadmill walking

  • This section will discuss the torque profiles obtained from the original, optimized and optimized extended versions of the RNM, and compare those to the torques found by inverse dynamics

Read more

Summary

Introduction

Active and portable prosthetic and orthotic (P/O) devices for the lower extremities have the potential to improve mobility and quality of life for individuals with reduced mobility [1], [2]. Effective control of an active P/O device requires understanding of human control of gait. The work presented here was performed as part of the the SYMBITRON project which is supported by EU research program FP7, FET-Proactive initiative “Symbiotic human-machine interaction” (ICT-2013-10) under project contract #611626. H. van der Kooij are with the Department of Biomechanical Engineering of the University of Twente, The Netherlands.

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call