Abstract
A smooth and dense surface of the base paper is advantageous when the goal is to apply a liquid coating as a barrier layer. For such a base paper, non-wood fibers derived from wheat straw could be an alternative to wood fibers. In this research paper, wheat straw pulp was refined with different beating levels (up to 600 revolutions) followed by different calendering pressure loads (up to 50 N/mm) to test its influence on mechanical and surface properties. Alkyl ketene dimer (AKD) was used as sizing agent with concentrations up to 0.2 wt% followed by a mineral-based precoating to test its influence on the smoothness. Eucalyptus pulp was chosen as a benchmark. After beating, the initial Schopper-Riegler degrees of 28 °SR increased to 56 °SR. Beating also increased the tensile index from 24 to 49 Nm/g, the burst index from 1.2 to 2.8 kPa·m²/g, and the tear index decreased from 3.3 to 2.8 mN·m2/g. Calendering reduced the initial roughness of 370 mL/min to 30 mL/min. When precoated and calendered again, the value was lowered to 15 mL/min. In summary, wheat straw paper is a relevant alternative to wood-derived base paper to produce barrier papers. Compared to eucalyptus, wheat straw paper showed better smoothness and much lower air permeability indicating excellent suitability for barrier coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have