Abstract
This study examines the correlation between the weight-bearing (WB) long leg radiograph (LLR)-derived hip-knee-ankle angle (HKAA) and intraoperative supine computer-assisted surgery (CAS)-derived HKAA measurements at the beginning and end of total knee arthroplasty (TKA). The primary aim of the study was to determine if WB alignment could be mimicked or inferred based on intraoperative alignment findings. We conducted a prospective analysis from a cohort of 129 TKAs undergoing a CAS TKA at a single center by a single surgeon. The HKAA was recorded using the CAS navigation system immediately postregistration of navigation data and after implantation of the prosthesis. The intraoperative HKAA was recorded in both the supine "resting" position of the knee and also while the knee was manipulated in an effort to replicate the patient's WB alignment. These measurements were compared with the HKAA recorded on pre- and postoperative WB LLRs. There was a strong correlation between the preoperative WB LLR HKAA and the intraoperative preimplant CAS-derived stressed HKAA (R = 0.946). However, there was no correlation between the postoperative WB LLR HKAA and the postimplant insertion HKAA as measured intraoperatively via CAS for either a "resting" or "stressed" position of the operated knee (R = 0.165 and R = 0.041, respectively). Thus, the interpretation of intraoperative alignment data is potentially problematic. Despite technological advances in the development and utilization of computer navigation and robotics in arthroplasty to help obtain the optimal alignment, it would seem apparent from our study that this alignment does not correlate to upright stance postoperatively. Surgeons should apply caution to the strength of assumptions they place on intraoperative coronal plane alignment findings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.