Wetting and premelting of triple junctions and grain boundaries in the Al–Zn alloys

Abstract

Phase transitions in grain boundaries (GBs) and GB triple junctions (TJs) can change drastically the properties of polycrystals. The GB and TJ wetting phase transition can occur in the two-phase area of the bulk phase diagram where the liquid and solid phases are in equilibrium. The GB and TJ wetting tie-lines can continue in one-phase area of the bulk phase diagram as a GB or TJ solidus line. This line represents the GB or TJ premelting phase transition. The structure and composition of grain boundaries and GB triple junctions were studied by high-resolution electron microscopy and analytical transmission electron microscopy in the Al–5 at.% Zn polycrystals and by differential scanning calorimetry (DSC) in the Al–7.5 at.% Zn polycrystals. Between bulk solidus and GB or TJ solidus the metastable Zn-rich β m-phase was observed in the GB triple junctions of quenched samples. This phase appears neither in the samples annealed above the bulk solidus nor in those annealed below the GB solidus. Zn-content in this β m-phase corresponds to that of bulk liquidus. This is a structural indication that if the melt wets the GBs or TJs, the GB (or TJ) solidus line appears in the bulk phase diagram, and the liquid-like phase exists in GBs and TJs between bulk solidus and GB (or TJ) solidus lines. The structural observation of this phase is also supported by our data obtained by means of DSC.