Abstract
AbstractIn this report, the surface topography of crescent array in the Nepenthes slippery zone is measured and bionic fabricated by two‐photon polymerization (TPP) technology. A subregion outside‐in scanning method (SOSM) is proposed to solve the photoresist converge and large area surface positioning problem existing in bionic crescent array surface (BCAS) fabrication. The geometric parameters of BCAS, including area fraction, height, offset, and outer–inner radius ratio, are systematically investigated to reveal their effects on the hydrophobic performance. Perfluorinated polyether oil and fluorocarbon solvent were used to increase the hydrophobicity and homogeneity of bionic surface. The contact angles of BCASs coated with and without the solution are measured. The maximum contact angle can reach to 152.1°. What's more, considering the anisotropy of BCAS, anisotropic wetting research is conducted. Offset and outer–inner radius ratio are found to have obvious effects on the contact angle differences between convexity and concavity directions. The maximum contact angle difference can reach to 5.1°. Spreading and pinning phenomenon caused by droplet anisotropic wetting are observed and explained. This work is expected to provide references for the BCAS to be applied in super‐hydrophobic and droplets motion fields.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
