Wet chemical synthesis and characterization of CuO nanoparticles and their application in pool boiling heat transfer

Abstract

There are several ways to synthesis nanoparticles, including chemical, physical, and biological processes. In general, chemical approaches are thought to be the most effective for producing uniformly sized and stable nanoparticles. This study deals with the synthesis and characterization of copper oxide nanoparticles (CuO-NPs) that could be used in pool boiling heat transfer in the form of nanofluid. The wet chemical synthesis method was used in order to prepare copper oxide nanoparticles (CuO-NPs) using precursor copper nitrate trihydrate (Cu(NO3)2⋅3H2O) and citric acid in a molar ratio of 5:1 in ethylene glycol (C2H6O2) solvent. The nanoparticles were identified using their stability, crystal size, and particle size. FTIR, XRD, and UV–Visible Spectroscopy all provide evidence that CuO-NPs exist. The typical nanoparticle size, as determined by Zetasizer, was 72.87 nm. The Scherrer formula was used to ascertain the average crystallite size of nanoparticles, which was determined to be approximately 19.82 nm. Positive findings from the stability test on nanoparticles were obtained, and their zeta potential was about –32.51 mV. According to morphological analyses by SEM, the synthesized CuO-NPs were made up of evenly dispersed spheroid-shaped particles that were agglomerated. The amount of reducing agent and calcination temperatures has a significant impact on the nanoparticle's size. The results of the experiment show that the addition of nanoparticles has a significant impact on the value of critical heat flux (CHF).