Abstract
Weigh-in-motion (WIM) data provide an excellent opportunity to study the effects of actual traffic loads on bridges. Here procedures are presented for using WIM data to quantify the fatigue damage accumulated in steel bridges. These procedures allow comparisons of the impacts of truck traffic on various routes beyond simple comparisons of the numbers and gross vehicles weights of trucks in the traffic streams. The fatigue damage accumulation procedures are demonstrated using WIM traffic data collected in the state of Alabama. The results of the analysis show that approximately 20% of trucks are overloaded, that is, permit loads and illegal loads, and those trucks create more than 50% of the total damage based on the combined data from all the WIM locations in the state. The contribution of overloaded trucks to the total fatigue damage varies so that their contribution is less significant along some routes. A typical steel bridge with bottom flange coverplates was evaluated using the WIM data from 1 year for a heavily traveled route. This analysis shows that the fatigue life of the bridge was consumed at an annual rate consistent with a mean life of 100 years. These procedures have applications in planning weight limit enforcement, budgeting, and maintenance, and they have the potential for future use in planning inspection intervals.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Transportation Research Record: Journal of the Transportation Research Board
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.