Weibull reliability plots to study the strain rate effect on interfacial strengths of carbon fiber reinforced epoxy composites

Abstract

AbstractTwo‐parameter Weibull reliability plots are utilized to determine the effects of strain rate on the interfacial strengths of unidirectional carbon fiber reinforced epoxy (CFRE) composites. Laminate specimens with two different fiber orientations are tested to failure under flexural loading. Type 1 laminates with fibers running parallel to specimen length (fiber orientation of 0° with respect to specimen span length) enable measuring inter‐laminar shear strength (ILSS) of the interface (between adjacent lamina) with locus of failure along beam mid ply. Seventy‐two type 1 laminates are tested at five levels of flexural strain rates: 1.89 * 10−5 to 9.37 * 10−2 s−1. Type 2 laminates with fibers running perpendicular to specimen length (fiber orientation of 90° with respect to specimen span length) enable measuring intra‐laminar (matrix/fiber) peel strength (ILPS) for tensile (mode I) strength of the matrix/fiber interface with locus of failure at beam bottom ply. Thirty‐six type 2 laminates are tested at three levels of flexural strain rates: 2.09 * 10−5 to 3.49 * 10−3 s−1. For each level of strain rate, Weibull plots are constructed. Stress values at failure probability (Pf) of 63.1% are assigned as strength values. The results show a slight decrease of the Weibull modulus, m, with increasing strain rates. The modulus decreases from 12.37 to 10.49 and from 11.11 to 9.68, for laminates type 1 and 2, respectively. For laminates type 1, ILSS increases with increasing strain rates rising 16.1% over the range of the tested strain rates. For laminates type 2, ILPS increases with increasing strain rates rising 38.1% over the range.