Wearables Clock Synchronization Using Skin Electric Potentials

Abstract

Design of clock synchronization for networked nodes faces a fundamental trade-off between synchronization accuracy and universality of heterogeneous platforms, because a high synchronization accuracy generally requires platform-dependent hardware-level network packet timestamping. This paper presents TouchSync , a new indoor clock synchronization approach for wearables that achieves millisecond accuracy while preserving universality in that it uses standard system calls only, such as reading system clock, sampling sensors, and sending/receiving network messages. The design of TouchSync is driven by a key finding from our extensive measurements that the skin electric potentials (SEPs) induced by powerline radiation are salient, periodic, and synchronous on a same wearer and even across different wearers. TouchSync integrates the SEP signal into the universal principle of Network Time Protocol and solves an integer ambiguity problem by fusing the ambiguous results in multiple synchronization rounds to conclude an accurate clock offset between two synchronizing wearables. With our shared code, TouchSync can be readily integrated into any wearable applications. Extensive evaluation based on our Arduino and TinyOS implementations shows that TouchSync's synchronization errors are below 3 and 7 milliseconds on the same wearer and between two wearers 10 kilometers apart, respectively.