Abstract
Laser surface alloying with gaseous nitrogen was utilized to improve the wear resistance of a Ti–6Al–4V alloy. Wear-resistant composite coatings reinforced by hard TiN dendrites were produced ‘in-situ’ on a substrate of a Ti–6Al–4V alloy. The hardness and wear resistance of the laser alloyed coating under two-body abrasive and block-on-ring full-sliding wear conditions were significantly enhanced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.