Abstract
Poly-ether-ether-ketone (PEEK), having shown favorable biocompatibility in spinal applications is being considered as an alternative biomaterial in orthopaedics, either as part of an all-polymer bearing couple, or a replacement for the metallic component in hard-on-soft bearings. Throughout the literature ultra-high molecular weight polyethylene exhibits a range of wear behavior dependent upon the amount of cross shear (CS) present in the bearing motion; in comparison, the behavior of PEEK bearing combinations subject to cross shear conditions is less understood. The aim of this study was to investigate the effect of cross shear on PEEK-on-PEEK and PEEK-on-Metal bearing couples. Wear tests were conducted using a four station pin-on-plate rig capable of uni-directional motion (zero cross shear) and multidirectional motion (cross shear); reciprocation (1 Hz), rotation (0 or 1 Hz), with gravimetric wear analysis used to determine the wear factors. The combined wear factors from the PEEK pins articulating on either PEEK or metal plates in this study suggest that it is preferable to use PEEK-on-Metal bearing couples under zero cross shear kinematic conditions and PEEK-on-PEEK for high cross shear applications. PEEK appears to demonstrate a CS dependency when articulating on hard surfaces. © 2018 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 107B: 445-453, 2019.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of biomedical materials research. Part B, Applied biomaterials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
