Wear properties of Al6061/SiC + B4C + TiC hybrid composites produced by vacuum infiltration method

Abstract

Abstract In the study, hybrid metal matrix composite (HMMC) structures were produced by vacuum infiltration method (VIM) using Al6061 alloy and varying amounts of SiC, B4C, and TiC ceramic powder pairs. Age-hardening processes were applied to these HMMCs. After heat treatment, wear behavior was examined under different loads using the pin-on-disc test method. All Al6061 hybrid composites exhibited better wear performance than unreinforced Al6061. In the wear tests of composite samples, the lowest volume loss and therefore the highest wear resistance were obtained in Al6061 3 wt.% B4C + SiC composites under 5 N force. The lowest wear resistance due to the highest volume loss was determined in Al6061/1 wt.% TiC + B4C composites under 15 N force. Abrasive and adhesive wear characteristics were observed in field emission scanning electron microscopy(FESEM) images of worn surfaces. Additionally, wear debris, smearing, and deep grove formations were determined on the surface. In the EDS analysis performed on the worn surface, O and Fe elements were found in addition to the elements that are likely to be in the structure (such as Al, B, C, Ti, Si, and Mg). The wear tests caused the formation of oxide layers on the sample surfaces.