Abstract
The characteristics of adhesive wear of TiN coating in drawing process by using finite element method were carried out to investigate the effects of drawing angles and sliding velocities of punch to explained wear index. Bending radius of die was used to increase the contact pressure between stainless sheet and TiN coating surface. Three sliding velocities (0.5, 1 and 5 mm/s) were studied each bending angle between (0O to 90O) by keeping the hardness of material coating to 24 GPa (HV.0.05). The results showed that the wear index were decreased with drawing angle but sliding speed of punch was not affected in slightly speed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
