Abstract
Wear is one of the common degradations in a commercial gas turbine. A stainless steel grade 304 (SS 304) fuel nozzle and its collar made of nickel-based superalloy (Hastelloy X) are two vital components that normally suffer from rapid wear. During an installation, the fuel nozzle is slotted into the collar of the combustion liner. In operation, these two surfaces are subjected to high pressure from the fuel combustion, hence continuously rubbing against each other causes vibrations. During the start–stop operation, these surfaces had undergone a large relative motion. The vibration is the main cause of the wear occurrence on the surfaces. Physical properties of the worn surfaces were obtained through visual observations: wear measurement, hardness and microstructure examination. Through visual observations, fretting wear was mainly suspected as the dominant wear mode, particularly after 8,000 of running hours at high temperature and vibration. In short, this paper discusses the preliminary findings of wear on the fuel nozzle and its collar. It also discusses the changes in the mechanical properties before and after the operation. Solutions for mitigating the problem were discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
