Wear behavior of HPPMS deposited (Ti,Al,Si)N coating under impact loading

Abstract

AbstractOver the last decade the interest in High Power Pulse Magnetron Sputtering (HPPMS) and High impulse Magnetron Sputtering (HiPIMS) has undergone a considerable increase. This is mainly due to the fact that several researchers have shown that in these processes a distinct increase of the ionization of deposition species is observable. However, there is only little known about the performance of these films with regard to applications. Recently Hovsepian et al. [1] and Bobzin et al. [2] presented cutting results of different films. Both authors show that films deposited using HPPMS or HiPIMS outperform state‐of‐the‐art coatings. Depending on the cutting process, besides hardness and adhesion also excellent impact behavior is required. Therefore this work deals with the impact behavior of (Ti,Al,Si)N which was deposited using HPPMS for the application in interrupted cutting process. The impact behavior of HPPMS coating under normal and tangential loads is analyzed. During impact tests number of impacts, loads and inclination angle of the samples with regard to the load direction are varied. (Ti,Al,Si)N shows an excellent endurance even at very high loads causing Hertzian stresses in the range of 10–13 GPa. At an inclination angle of 10° and an impact load of 100 N, which corresponds to app. 10 GPa initial Hertzian stress, no damage was observed after 800×103 impacts.