Abstract
In this investigation, the influence of tool rotational speed on wear and mechanical properties of Aluminum alloy based surface hybrid composites fabricated via Friction stir processing (FSP) was studied. The fabricated surface hybrid composites have been examined by optical microscope for dispersion of reinforcement particles. Microstructures of all the surface hybrid composites revealed that the reinforcement particles (SiC, Gr and Al2O3) are uniformly dispersed in the nugget zone. It is observed that the microhardness is decreased with increasing the rotational speed and exhibited higher microhardness value in Al-SiC/Al2O3 surface hybrid composite at a rotational speed of 900 rpm, due to presence and pining effect of hard SiC and Al2O3 particles. It is also observed that high wear resistance exhibited in the Al-SiC/Gr surface hybrid composites at a rotational speed of 900 rpm due to presence of SiC and Gr acted as load bearing elements and solid lubricant respectively. The observed wear and mechanical properties have been correlated with microstructures and worn morphology.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
