Weak interfacial water ordering on isostructural hematite and corundum (0 0 1) surfaces

Abstract

Ordering of interfacial water at the hematite and corundum (0 0 1)–water interfaces has been characterized using in situ high resolution specular X-ray reflectivity measurements. The hematite (0 0 1) surface was prepared through an annealing process to produce a surface isostructural with corundum (0 0 1), facilitating direct comparison. Interfacial water was found to display a similar structure on this pair of isostructural surfaces. A single layer of adsorbed water having a large vibrational amplitude was present on each surface and additional ordering of water extended at least 1 nm into the bulk fluid, with the degree of ordering decreasing with increasing distance from the surfaces. Consistent with prior studies of the (0 1 2) and (1 1 0) surfaces of hematite and corundum, the configuration of water above the (0 0 1) surfaces is primarily controlled by the surface structure, specifically the arrangement of surface functional groups. However, interfacial water at the (0 0 1) surfaces displayed significantly larger vibrational amplitudes throughout the interfacial region than at other isostructural sets of hematite and corundum surfaces, indicating weaker ordering. Comparison of the vibrational amplitudes of adsorbed water on a series of oxide, silicate, and phosphate mineral surfaces suggests that the presence or absence of a substantial interfacial electrostatic field is the primary control on water ordering and not the surface structure itself. On surfaces for which charge originates dominantly through protonation–deprotonation reactions the controlling factor appears to be whether conditions exist where most functional groups are uncharged as opposed to the net surface charge. The doubly coordinated functional groups on hematite and corundum (0 0 1) surfaces are largely uncharged under slightly acidic to circumneutral pH conditions, leading to weak ordering, whereas singly coordinated groups on (0 1 2) and (1 1 0) surfaces of these phases are always charged, even when the net surface charge is zero, and induce strong water ordering. Surfaces lacking structural charge can thus be divided into two distinct classes that induce either strong or weak ordering of interfacial water. Surface functional group coordination is the ultimate control on this division as it determines the charge state of such groups under different protonation configurations. Ion adsorption and electron transfer processes may differ between these classes of surfaces because of the effect of water ordering strength on interfacial capacitances and hydrogen bonding.