Abstract

Hyperspectral imaging (HSI) in the spectral range of 400–1000 nm was tested to differentiate three different particle size fractions of milk powder. Partial least squares discriminant analysis (PLS-DA) was performed to observe the relationship of spectral data and particle size information for various samples of instant milk powder. The PLS-DA model on full wavelengths successfully classified the three fractions of milk powder with a coefficient of prediction 0.943. Principal component analysis (PCA) identified each of the milk powder fractions as separate clusters across the first two principal components (PC1 and PC2) and five characteristic wavelengths were recognised by the loading plot of the first three principal components. Weighted regression coefficient (WRC) analysis of the partial least squares model identified 11 important wavelengths. Simplified PLS-DA models were developed from two sets of reduced wavelengths selected by PCA and WRC and showed better performance with predictive correlation coefficients (Rp2) of 0.962 and 0.979, respectively, while PLS-DA with complete spectrum had Rp2 of 0.943. Similarly, classification accuracy of PLS-DA was improved to 92.2% for WRC based predictive model. Calculation time was also reduced to 2.1 and 2.8 s for PCA and WRC based simplified PLS-DA models in comparison to the complete spectrum model that was taking 32.2 s on average to predict the classification of milk powder samples. These results demonstrated that HSI with appropriate data analysis methods could become a potential analyser for non-invasive testing of milk powder in the future.

Highlights

  • Milk powder quality is complex as it is measured in terms of different quality attributes such as milk powder appearance, taste, aroma, and its dissolution performance in water

  • This paper aims to evaluate the potential of Hyperspectral imaging (HSI) techniques to facilitate the rapid testing of milk powder

  • The samples from seven batches were used for the model calibration and andthe thesamples samplesfrom fromthe theother otherthree threebatches batcheswere wereused usedfor forthe the model validation

Read more

Summary

Introduction

Milk powder quality is complex as it is measured in terms of different quality attributes such as milk powder appearance, taste, aroma, and its dissolution performance in water. These quality attributes of milk powder depend on various physical (e.g., particle size distribution, bulk density) and functional properties (e.g., wettability, sinkability, dispersibility, and solubility) of milk powder. Milk powder quality is measured after the fact and offline using various quality tests which include quality test(s) for measuring powder bulk density, powder flowability and dispersibility in water, etc These quality tests have inherent variability and lack numeric descriptors which makes milk powder quality quantification challenging. This offline strategy of testing milk powder quality is not helpful to detect

Objectives
Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.