Abstract

The watertight closure of the dura mater is fundamental to intracranial supratentorial procedures in neurosurgery. Controversies exist claiming the superiority of one closure technique over another. But is ‘Water-tight’ dural closure really achievable ? An in vitro study system was developed to test the pressures at which dural incisions, closed with sutures, leaked. Bovine dura was secured to the lower end of an open ended calibrated plastic cylinder. Multiple interrupted stitches were applied over a two 2 cm length of the dura without any incision. Similarly a 2 cm incision was made and closed with interrupted and continuous stitches. Cylinder was filled with colored saline gradually. Height of the water column at which sutured dura leaked was recorded. The tests were conducted with the dura both in lax and tense conditions. Inlay closure technique was also tested on the same model using a dural substitute. Even without an incision, needle puncture sites over a dura, leak, at a very low hydrostatic pressure (30 In the experimental model described, ‘Water-tight’ dural closure appears to be impossible with suture closure of a dural defect.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.