Abstract
In order to improve the processing quality of wood parts, an orthogonal experimental design of five factors and four levels was adopted, and a water-jet assisted laser cutting experiment on Korean pine (Pinus koraiensis) was conducted. Moreover, by using range analysis, the influences of the defocusing amount, cutting speed, laser power, water pressure, and water jet angle on the processing quality of Korean pine parts were evaluated, and the optimum process parameters were determined. The test results show that when the defocusing amount was -1 mm, water jet angle was 30°, laser power was 48 W, water pressure was 1.0 MPa, and cutting speed was 25 mm/s, the best processing quality of Korean pine parts was obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.