Abstract

Using Fourier transform infrared spectroscopy (FTIR), we measured water contents of quartz and feldspar for four thin sections of felsic mylonite and two thin sections of banded granitic gneiss collected from a ductile shear zone of middle crust along the Red Rivers-Ailaoshan active fault. The absorbance spectra and peak position suggest that water in quartz and feldspar of granitic gneiss and felsic mylonite occurs mainly as hydroxyl in crystal defect, but also contains inclusion water and grain boundary water. The water contents of minerals were calculated based on the absorbance spectra. Water content of feldspar in granitic gneiss is 0.05 wt%-0.15 wt%, and that of quartz 0.03 wt%-0.09 wt%. Water content of feldspar ribbon and quartz ribbon in felsic mylonite is 0.095 wt%-0.32 wt%, and those of fine-grained feldspar and quartz are 0.004 wt%-0.052 wt%. These data show that the water content of weakly deformed feldspar and quartz ribbons is much higher than that of strongly deformed fine-grained feldspar and quartz. This suggests that strong shear deformation leads to breakage of the structures of constitutional water, inclusion and grain boundary water in feldspar and quartz, and most of water in minerals of mylonite is released to the upper layer in the crust.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.