Abstract
Abstract The objective of this study is to investigate the impact of different porous metal samples on the hydro-thermal characteristics of a single cylinder with porous fins using computational fluid dynamics. Commercially used porous samples with pore densities of 10, 20, and 40 PPI were used in this study for heat recovery from exhaust flue gas. The three-dimensional computational domain with porous aluminium fins attached to a tube over which high-temperature exhaust gas flows in a crossflow arrangement mimics a waste heat recovery system. Computations were performed at Reynolds number of 6000-9000, using the realisable κ-ϵ turbulence model. Three fin diameter to tube diameter ratios (Df/D = 2, 2.5, and 3) were considered. The local thermal non-equilibrium model is implemented for energy transfer, as it is more accurate for a high-temperature gradient scenario in a waste heat recovery system. The foam sample with the highest pore density was observed to have the highest pressure drop due to low permeability. A maximum heat transfer and Nusselt number were achieved for a 40 PPI foam sample due to a reduced flow rate inside the porous zone. The overall performance of metal foam samples at varying fin diameters was evaluated based on the area goodness factor (j/f) and a heat transfer coefficient ratio to pumping power per unit heat transfer surface (Z/E). Analysis of these two parameters suggests using 20 PPI foam at Df/D = 2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Thermal Science and Engineering Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.