VSWIR to VLWIR MBE grown HgCdTe material and detectors for remote sensing applications

Abstract

The molecular beam epitaxy (MBE) growth technology is inherently flexible in its ability to change the Hg1−xCdxTe material’s bandgap within a growth run and from growth run to growth run. This bandgap engineering flexibility permits tailoring the device architecture to the various specific requirements. Material with active layer x values ranging from ∼0.198 to 0.570 have been grown and processed into detectors. This wide range in x values is perfectly suited for remote sensing applications, specifically the National Polar Orbiting Environmental Satellite System (NPOESS) program that requires imaging in a multitude of infrared spectral bands, ranging from the 1.58 to 1.64 µm VSWIR (very short wave infrared) band to the 11.5 to 12.5 µm LWIR (longwave infrared) band and beyond. These diverse spectral bands require high performance detectors, operating at two temperatures; detectors for the VSWIR band operate near room temperature while the SWIR, MWIR (mid wave infra red), LWIR and VLWIR (very long wave infrared) detectors operate near 100K, because of constraints imposed by the cooler for the NPOESS program. This paper uses material parameters to calculate theoretical detector performance for a range of x values. This theoretical detector performance is compared with median measured detector optical and electrical data. Measured detector optical and electrical data, combined with noise model estimates of ROIC performance are used to calculate signal to noise ratio (SNR), for each spectral band. The SNR are compared with respect to the meteorological NPOESS system derived focal plane. The derived system focal plane requirements for NPOESS are met in all the spectral bands.