Voltammetric and EQCM investigation of conductive films formed by electroreduction of Ru(L)(CO) 2Cl 2 compounds

Abstract

Electroreduction of trans(Cl) and cis(Cl)Ru(L)(CO) 2Cl 2 (L=bpy=2,2′-bipyridine, dmbpy=4,4′-dimethyl-2,2′-bipyridine) in CH 3CN and DMSO resulted in electrode-adhering films and the reactions were studied by voltammetry and the electrochemical quartz crystal microbalance. These methods were complemented by hydrodynamic rotating ring-disc and quartz crystal impedance methods. The deposition was strongly influenced by the type of solvent, polarisation mode and electrolyte stirring, but for all compounds, rapid charge transfer was found. For monomers with trans(Cl)Ru(bpy)(CO) 2Cl 2, the two-electron reduction and Ru 0Ru 0 polymerisation process suggested in the literature was confirmed. Some adsorption of CH 3CN was also indicated and for potentiostatic deposition in static solution the impedance measurements indicated increased film viscoelasticity. Depositions with cis(Cl)Ru(bpy)(CO) 2Cl 2 were more complex and the rate declined gradually in static solution. In stirred solution a straightforward polymer formation took place. For trans(Cl)Ru(dmbpy)(CO) 2Cl 2 the literature mechanism could not be confirmed and large deviations were observed during the early stages of deposition. The trans(Cl) dimer, [Ru(bpy)(CO) 2Cl] 2 displayed a lower current efficiency during film formation than the monomer and no simple deposition mechanism could be suggested. For the trans(Cl)[Ru(dmbpy)(CO) 2Cl] 2 dimer a straightforward deposition was found. The films could be removed by electrooxidation and mass/charge data show that the films break up in large fragments. The reduction and deposition process for trans(Cl) monomers (L=bpy, dmbpy) was light sensitive and the mass of films deposited during cyclic voltammetry (CV) was doubled when the electrode was irradiated.