Abstract

As an indispensable part of Internet of Things (IoT), wireless sensor networks (WSNs) are more and more widely used with the rapid development of IoT. The neighbor discovery protocols are the premise of communication between nodes and networking in energy-limited self-organizing wireless networks, and play an important role in WSNs. Because the node energy is limited, neighbor discovery must operate in an energy-efficient manner, that is, under the condition of a given energy budget, the neighbor discovery performance should be as good as possible, such that the discovery latency would be as small as possible and the discovered neighbor percentage as large as possible. The indirect neighbor discovery mainly uses the information of the neighbors that have been found by a pairwise discovery method to more efficiently make a re-planning of the discovery wake-up schedules of the original pairwise neighbor discovery, thereby improving the discovery energy efficiency. The current indirect neighbor discovery methods are mainly divided into two categories: one involves removing the inefficient active slots in the original discovery wake-up schedules, and the other involves adding some efficient active slots. However, the two categories of methods have their own limitations. The former does not consider that this removal operation destroys the integrity of the original discovery wake-up schedules and hence the possibility of discovering new neighbors is reduced, which adversely affects the discovered neighbor percentage. For the latter category, there are still inefficient active slots that were not removed in the re-planned wake-up schedules. The motivation of this paper is to combine the advantages of these two types of indirect neighbor discovery methods, that is, to combine the addition of efficient active slots and the removal of inefficient active slots. To achieve this goal, this paper proposes, for the first time, the concept of virtual nodes in neighbor discovery to maximize the integrity of the original wake-up schedules and achieve the goals of adding efficient active slots and removing inefficient active slots. Specifically, a virtual node is a collaborative group that is formed by nodes within a small range. The nodes in a collaborative group share responsibility for the activating task of one member node, and the combination of these nodes’ wake-up schedules forms the full wake-up schedule of a node that only uses a pairwise method. In addition, this paper proposes a set of efficient group management mechanisms, and the key steps affecting energy efficiency are analyzed theoretically to obtain the energy-optimal parameters. The extended simulation experiments in multiple scenarios show that, compared with other methods, our neighbor discovery protocol based on virtual nodes (VN-NDP) has a significant improvement in average discovery delay and discovered neighbor percentage performance at a given energy budget. Compared with the typical indirect neighbor discovery algorithm EQS, a neighbor discovery with extended quorum system, our proposed VN-NDP method reduces the average discovery delay by up to and increases the discovered neighbor percentage by up to .

Highlights

  • In recent decades, thanks to the rapid development of electronic technologies and wireless communications, wireless sensor networks (WSNs) have attracted the attention of academics and industrialists [1,2]

  • When duty cycle (DC) is less than or equal to 3%, the average discovery latencies (ADLs) of virtual-node based indirect neighbor discovery protocol (VN-NDP)+Disco is always less compared with EQS+Disco, indicating that VN-NDP+Disco is better than EQS+Disco in terms of ADL performance in this case

  • Neighbor discovery protocol plays an important role in wireless sensor networks because it is a prerequisite for communication between nodes in WSNs

Read more

Summary

Introduction

Thanks to the rapid development of electronic technologies and wireless communications, wireless sensor networks (WSNs) have attracted the attention of academics and industrialists [1,2]. A typical example of the application of IoT-oriented WSN is that WSNs can be used for collecting data in IoT in a large number of contexts, such as intelligent manufacturing sites. A WSN is composed of many inexpensive micro sensor nodes and one sink node. These sensor nodes establish a network in a self-organizing manner. They collect data and forward the data to the sink node. The data collected by the sink node can be forwarded to the cloud since the sink node can usually access the Internet in a wired or wireless communication manner [9]

Objectives
Methods
Findings
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call