Visualization of temporal differences between dominant perceptions in temporal dominance of sensations (TDS) and temporal check-all-that-apply (TCATA) perceptions using dominance-highlighted TCATA (dTCATA) curves

Abstract

The temporal dominance of sensations (TDS) method measures dynamic changes of panelists’ attention to the sensory attributes of products. The temporal check-all-that-apply (TCATA) method measures all sensory attributes perceived at each moment of an evaluation. However, unlike in TDS, significant levels cannot be calculated in TCATA. This study proposes the use of dominance-highlighted TCATA (dTCATA) curves, which are highlighted TCATA curves that show significant time periods for the TDS data of different panels. Twelve R&D panelists evaluated five commercial corn soups using the TCATA method. Then, 125 consumer panelists evaluated the same products using the TDS method. The dTCATA curves showed TCATA curves for all attributes for each product evaluated by the R&D panel highlighted with the dominance rates identified by the consumer panel in the TDS evaluation. For example, for product 1, some attributes (sweet, viscosity) showed relatively high citation proportions in the TCATA evaluations of the R&D panel and significant dominance rates in the TDS evaluations of the consumer panel. In contrast, consommé flavor showed relatively low citation proportions in TCATA but significant dominance rates in TDS. By merging TDS and TCATA data, we could compare consumers’ dominant sensations with the evaluations of R&D panelists. This comparison could provide useful insights to product developers. In some cases, we observed attributes with significant dominance rates that were under-identified by the R&D panel in TCATA. This could suggest that most of the R&D panel may not have perceived these attributes; therefore, during product development, these attributes should be carefully considered.