Abstract
AbstractThe molecular orientation of a frozen layer in an injection‐molded specimen of a polypropylene–rubber blend was investigated. A typical V‐shaped pattern of birefringence was observed from the surface to the core in a crosscut section. From the comparison of the V‐patterns near the gate to the flow end, it was assumed that a frozen layer formed from the surface to a depth of 0.06 mm in a plaque (3 mm thickness) during the injection molding filling process. Numerical viscoelastic analysis of the fountain flow was carried out using an original 2D unsteady flow simulation program and ignored crystallization. A large extensional deformation formed just when the molten polymer contacted the cavity wall and the deformation immediately froze. A layer with a small birefringence between the surface and the shear‐oriented layer was divided into two parts. The depth profile of birefringence was compared to the principal stress difference calculated by numerical analysis. POLYM. ENG. SCI., 2010. © 2010 Society of Plastics Engineers
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
