Abstract
The paper presents aspects regarding the virtual modeling, detailed design and FEM analysis of a testing device, to be used to fix small pieces in tribological tests. First there are presented some aspects of the device virtual modeling and drafting, using CATIA software. Then are defined the geometrical and kinematical restrictions between the parts. Finally, there are presented some aspects about the Finite Element Analysis and the results of this, using ANSYS software. In the final part of the paper, there are presented the conclusions of the simulation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.