Abstract

This paper describes, a novel innovative design for generating vibration signals in a bearing, which is in static mode not in dynamic mode like other usual measurements reported in literatures, for various types of bearing faults analysis supports users with a technique based on monitoring vibration signals. This paper reports the computed power spectrum from vibration signal clearly identifies the fault signature with its raise in amplitude. Hence, in an impulse excitation technique vibration analysis with computed power spectrum provides an efficient monitoring of fault in axle bearings in a short timing. Programmable System on Chip (PSoC) creator design and Virtual Instrument program written in LabVIEW, a graphical language, provides efficient implementation of impulse excitation technique possible in static test method in a minimal time.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.