Abstract
This paper deals with the application of cohesive zone models to study delamination failures in leg-angles of pultruded glass fibre reinforced polymer material using the general-purpose finite element software Abaqus. The objective of the study is to present a finite element modelling methodology that can, for example, help to fill-in knowledge gaps in the available experimental data pertaining to the tying force resistance of angle-cleated jointing in frame construction. It may be used to optimize cleat shape and laminate lay-up (dependent on composite processing method) for the strongest cleat against a minimum cost requirement. A benchmark example taken from literature is used to show that the numerical predictions from the authors' simulations are reliable. The approach is next used to analyse an equal leg-angle component where one leg is fixed and the other orthogonal leg is being deformed by a tensile force applied over the free end surface. Numerical results from Abaqus are used to show that a laminate produced by the pultrusion processing method fails unstably by delamination cracks radiating around the curved region and extending into the leg panels. As a preliminary study to show the potential of the new modelling methodology it is used to show the influence of the radius of curvature at the junction between the legs on the tying force resistance; based on the load at delamination onset a smaller radius reduces the cleat's strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have