Vinyl-Asbestos Floor Risk Exposure in Three Different Simulations.

Abstract

Vinyl floors are widely used in public areas for their low cost and easy cleaning. From 1960 to 1980, asbestos was often added to improve vinyl floor performances. The Italian Ministerial Decree (M.D.) 06/09/94 indicates asbestos vinyl tiles as non-friable materials and, therefore, few dangerous to human health. This work aims to check through three different experimental tests if asbestos floor tiles, after decades of use, maintain their characteristics of compactness and non-friability. The effect of a small stone fragment stuck in the sole of rubber shoes was reproduced by striking the vinyl floor with a crampon. A vinyl tile was broken into smaller pieces with the aid of pliers to simulate what normally happens when workers replace the floors or sample it to verify the presence of asbestos. The third test reproduced the abrasion of the tile surface due to the dragging of furniture or heavy materials or sand grains that remain attached to the soles of shoes. The tests were carried out in safe conditions, working under an extractor hood with a glove box. Airborne sampling in the hood obtained the concentration of asbestos fibers produced in each test. The simulation tests performed confirms the possible release of fibers if the vinyl tiles are cut, abraded or perforated, as indicated by the Italian M.D.