Vibration isolation characteristics of a nonlinear isolator using Euler buckled beam as negative stiffness corrector: A theoretical and experimental study

Abstract

Abstract This paper concerns the vibration isolation characteristics of a nonlinear isolator using Euler buckled beams as negative stiffness corrector. Both analytical and experimental studies are carried out. The Harmonic Balance Method (HBM) is used to determine the primary resonance response for the single degree of freedom (SDOF) nonlinear system composed by a loaded mass and the nonlinear isolator. The distuning of the loaded mass is taken into consideration, resulting in a Helmoholtz–Duffing equation. The performance of the nonlinear isolator is evaluated by the defined two kinds of transmissibility and compared with that of the linear isolator without the stiffness corrector. The study shows that the asymmetric SDOF nonlinear system can behave like a purely softening, a softening–hardening or a purely hardening system, depending on the magnitude of the excitation level. An experimental apparatus is set up to validate the analytical results. The transmissibility results of the SDOF nonlinear system under base excitation with both discrete sinusoidal frequencies and slowly forward and backward sweeps are given and discussed. The complex jump phenomena under different excitation levels are identified. By introducing the stiffness corrector, the starting frequency of isolation of the nonlinear isolator is found to be lower than that of the linear one with the same support capacity. The proposed nonlinear isolator performs well in applications where the excitation amplitude is not too large.