Vibration control of two degrees of freedom system using variable inertia vibration absorbers: Modeling and simulation

Abstract

Variable inertia vibration absorbers (VIVA) are previously used for the vibration control of single degree of freedom (dof) primary systems. The performance of such absorbers is studied in many investigations. This paper presents the dynamic modeling and simulation of a proposed modified design of such VIVA’s for the vibration control of two dof primary systems. Lagrange formulation is used to obtain its dynamic model in an analytical form. This model, which is highly nonlinear, is used to develop a computational algorithm to study the absorber performance characteristics. This algorithm is programmed and simulated in Matlab. The obtained results are numerically verified using SAMS2000 software. The effect of mass and stiffness of the proposed VIVA on its performance and tuning is discussed. An optimization algorithm is developed to select the best absorber parameters for vibration suppression of a specific primary system. The obtained results show a good agreement with those obtained using similar techniques. In addition, a linearized model of VIVA dynamics is developed, tested and simulated for the same data used in its nonlinear model. The relative deviation between results of the linear and nonlinear models is less than 1%, which confirms the realistic use of this linearized model. The experimental testing and verification of the simulation results of the proposed VIVA is the subject of another paper.