Vibration-Based Approach to Measure Rail Stress: Modeling and First Field Test.

Abstract

This paper describes a non-invasive inspection technique for the estimation of longitudinal stress in continuous welded rails (CWR) to infer the rail neutral temperature (RNT), i.e., the temperature at which the net longitudinal force in the rail is zero. The technique is based on the use of finite element method (FEM), vibration measurements, and machine learning (ML). FEM is used to model the relationship between the boundary conditions and the longitudinal stress of any given CWR to the vibration characteristics (mode shapes and frequencies) of the rail. The results of the numerical analysis are used to train a ML algorithm that is then tested using field data obtained by an array of accelerometers polled on the track of interest. In the study presented in this article, the proposed technique was proven in the field during an experimental campaign conducted in Colorado. A commercial FEM software was used to model the rail track as a short rail segment repeated indefinitely and under varying boundary conditions and stress. Three datasets were prepared and fed to ML models developed using hyperparameter search optimization techniques and k-fold cross validation to infer the stress or the RNT. The frequencies of vibration were extracted from the time waveforms obtained from two accelerometers temporarily attached to the rail. The results of the experiments demonstrated that the success of the technique is dependent on the accuracy of the model and the ability to properly identify the modeshapes. The results also proved that the ML was also able to predict successfully the neutral temperature of the tested rail by using only a limited number of experimental data for the training.