Abstract

Efficient evolution of hydrogen through electrocatalysis holds tremendous promise for clean energy. The catalytic efficiency for hydrogen evolution reaction (HER) strongly depends on the number and activity of active sites. To this end, making vertically aligned, ultrathin, and along with rich metallic phase WS2 nanosheets is effective to maximally unearth the catalytic performance of WS2 nanosheets. Metallic 1T polymorph combined with vertically aligned ultrathin WS2 nanosheets on flat substrate is successfully prepared via one-step simple hydrothermal reaction. The nearly vertical orientation of WS2 nanosheets enables the active sites of surface edge and basal planes to be maximally exposed. Here, we report vertical 1T-WS2 nanosheets as efficient catalysts for hydrogen evolution with low overpotential of 118 mV at 10 mA cm−2 and a Tafel slope of 43 mV dec−1. In addition, the prepared WS2 nanosheets exhibit extremely high stability in acidic solution as the HER catalytic activity and show no degradation after 5000 continuous potential cycles. Our results indicate that vertical 1T-WS2 nanosheets are attractive alternative to the precious platinum benchmark catalyst and rival MoS2 materials that have recently been heavily scrutinized for hydrogen evolution.Graphical Vertical 1T-WS2 for hydrogen evolution.

Highlights

  • Hydrogen, as a clean fuel, has been considered as a promising alternative for traditional fossil fuels in the future [1, 2]

  • Crisscross rather than stack occurred between nanosheets

  • Such an open structure is supposed to allow the fast transportation of proton throughout the catalyst and utilize the basal planet sites for hydrogen evolution reaction (HER) as well

Read more

Summary

Introduction

As a clean fuel, has been considered as a promising alternative for traditional fossil fuels in the future [1, 2]. Ultrathin WS2 nanosheets with perpendicular orientation and 1T metallic phase feature exhibit high activity and stability towards HER in acidic water. The loading mass of WS2 nanosheets was determined by weighing the titanium substrate before and after hydrothermal process; a surface density of approximately 100 μg cm−2 was obtained.

Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.