Vertically aligned MXene bioelectrode prepared by freeze-drying assisted electrophoretic deposition for sensitive electrochemical protein detection

Abstract

Two-dimensional (2D) carbides, MXenes, have attracted attention as electrode materials of electrochemical biosensors because of their metallic conductivity, hydrophilicity, and mechanical stability. However, when fabricating electrodes, the nanosheets tend to re-stack and generally align horizontally with respect to the current collector due to the highly anisotropic nature of MXene, resulting in low porosity and poor utilization of the MXene surface. Here we report the electrochemical biosensing of antibody-antigen reactions with a vertically aligned Ti3C2Tx MXene (VA-MXene) electrode prepared by freeze-drying assisted electrophoretic deposition. The macroporous VA-MXene electrode exhibited a better electrochemical response towards the immunoreaction between the allergenic buckwheat protein (BWp16) and the antibody compared to a non-porous, horizontally (in-plane) stacked MXene (HS-MXene) and the sensors reported in the literature. The sensor responsiveness, defined as the ratio of the obtained current density of the electrode to the antigen concentration, was much higher for the VA-MXene electrode (238 μA cm−2 (ng mL−1) −1) than for the HS-MXene electrode. The proposed technique is applicable to other exfoliated nanosheets, and will open a new avenue for porous nanosheet electrodes to improve the sensing characteristics of electrochemical biosensors.