Vertical ridge augmentation feasibility using unfixed collagen membranes and particulate bone substitutes: A 1- to 7-year retrospective single-cohort observational study.

Abstract

AimTo determine whether vertical ridge augmentation (VRA) can be obtained through guided bone regeneration (GBR) using exclusively resorbable collagen membranes and particulate bone substitutes without additional stabilization.Materials and MethodsThis study retrospectively examined 22 participants who underwent VRA with staged or simultaneous implant placement. The vertical defects of all participants were filled with particulate bone substitutes and covered with resorbable collagen membranes. The augmented sites were stabilized with unfixed collagen membranes and the flap without any additional fixation. The augmented tissue height was assessed using cone‐beam computed tomography at baseline, immediately after surgery, and at annual follow‐ups.ResultsThe vertical bone gain of the 22 augmented sites amounted to 6.48 ± 2.19 mm (mean ± SD) immediately after surgery and 5.78 ± 1.72 mm at 1‐ to 7‐year follow‐up. Of the 22 augmented sites, 18 exhibited changes of less than 1 mm, while the other 4 showed changes of greater than 1 mm. Histological observation of three representative cases revealed new bone apposition on the remaining material.ConclusionThe present findings indicate that GBR procedures using exclusively collagen membranes and particulate biomaterials without any additional fixation are feasible options for VRA.