Abstract

Abstract. Warm conveyor belts (WCBs) are important cyclone-related airstreams that are responsible for most of the cloud and precipitation formation in the extratropics. They can also substantially influence the dynamics of cyclones and the upper-level flow. So far, most of the knowledge about WCBs is based on model data from analyses, reanalyses and forecast data with only a few observational studies available. The aim of this work is to gain a detailed observational perspective on the vertical cloud and precipitation structure of WCBs during their inflow, ascent and outflow and to evaluate their representation in the new ERA5 reanalysis dataset. To this end, satellite observations from the CloudSat radar and the Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observation (CALIPSO) lidar are combined with an ERA5-based WCB climatology for nine Northern Hemisphere winters. Based on a case study and a composite analysis, the main findings can be summarized as follows. (i) WCB air masses are part of deep, strongly precipitating clouds, with cloud-top heights at 9–10 km during their ascent and an about 2–3 km deep layer with supercooled liquid water co-existing with ice above the melting layer. The maximum surface precipitation occurs when the WCB is at about 2–4 km height. (ii) Convective clouds can be observed above the inflow and during the ascent. (iii) At upper levels, the WCB outflow is typically located near the top of a 3 km deep cirrus layer. (iv) There is a large variability between WCBs in terms of cloud structure, peak reflectivity and associated surface precipitation. (v) The WCB trajectories with the highest radar reflectivities are mainly located over the North Atlantic and North Pacific, and – apart from the inflow – they occur at relatively low latitudes. They are associated with particularly deep and strongly precipitating clouds that occur not only during the ascent but also in the inflow and outflow regions. (vi) ERA5 represents the WCB clouds remarkably well in terms of position, thermodynamic phase and frozen hydrometeor distribution, although it underestimates the high ice and snow values in the mixed-phase clouds near the melting layer. (vii) In the lower troposphere, high potential vorticity is diabatically produced along the WCB in areas with high reflectivities and hydrometeor contents, and at upper levels, low potential vorticity prevails in the cirrus layer in the WCB outflow. The study provides important observational insight into the internal cloud structure of WCBs and emphasizes the ability of ERA5 to essentially capture the observed pattern but also reveals many small- and mesoscale structures observed by the remote sensing instruments but not captured by ERA5.

Highlights

  • Extratropical cyclones are typically associated with welldefined, moist ascending airstreams referred to as warm conveyor belts (WCBs; e.g. Harrold, 1973; Carlson, 1980; Wernli and Davies, 1997)

  • ERA5 reanalyses have been combined with satellite observations from the polar-orbiting CloudSat radar and Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observation (CALIPSO) lidar to gain a detailed observational perspective on the vertical cloud structure of WCBs during their inflow, ascent and outflow and to evaluate their representation in ERA5

  • The satellite observations revealed that the WCBs form part of vertically extended, strongly precipitating clouds, in particular during their ascent, with cloud-top heights at 9– 10 km

Read more

Summary

Introduction

Extratropical cyclones are typically associated with welldefined, moist ascending airstreams referred to as warm conveyor belts (WCBs; e.g. Harrold, 1973; Carlson, 1980; Wernli and Davies, 1997). Illingworth et al, 2007; Joos and Forbes, 2016) This highlights the importance of complementing our knowledge about WCBs and the embedded small-scale processes, which is mainly based on numerical model data, with observational studies. Studies based on CloudSat and CALIPSO measurements have provided invaluable insight into the distribution of clouds and precipitation in extratropical cyclones and the associated complex dynamical and physical processes. Vertical composites of frontal clouds based on CloudSat and CALIPSO data (Naud et al, 2010, 2012, 2014, 2015) revealed some similarities to the historical model but even more to the conveyor belt model and the WCB, with mid- and high-level clouds typically occurring to the east of the cold front and above the warm front.

Data and methods
Satellite observations
ERA5 reanalyses
WCB identification
Matches between WCB trajectories and CloudSat and CALIPSO overpasses
Selection of strong WCBs
Case study of a representative North Pacific WCB
Climatological analysis of the WCB cloud structure
Spatial distribution of the intersected WCB trajectories
Composites of reflectivity and DARDAR-retrieved IWC
All WCBs
Strong WCBs
Meteorological environment in ERA5
Findings
Summary and discussion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.