Abstract
The frame compliance is calibrated by experimental and calculation methods for an instrumented indentation equipment. The indentation depth and contact diameter with single cycle test is determined by confocal laser scanning microscopy directly. The alternative method is to calculate the contact depth and the contact radius from the load-depth curves. The observed and calculated frame compliances are obtained respectively according to EN ISO 14577-4 Annex Methods 2.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
