Velocity and Strain-Rate Characteristics of Opposed Isothermal Flows

Abstract

Velocity measurements in the isothermal flows created by an opposed nozzle configuration are reported with emphasis on the axis, stagnation plane and the distributions of mean and instantaneous strain rates. The instrumentation comprised particle image velocimetry (PIV) with silicon oil droplets added to the flows upstream of both nozzles with the laser sheet passing through the axis between the nozzles. The results identify the regions of high strain rates and quantify the development of the mean and turbulent components of the flow from the nozzle exits as a function of bulk velocities from 3 to 8.2 m/s and nozzle separations from 0.4 to 1.0 diameters. Results show, for example, the rise in the values of axial and radial normal stress towards the stagnation plane with values increasing by up to 300% and 160% respectively. The maximum mean strain rate occurred just over one nozzle radius from the axis at the smallest separation and with values that increased from 450 to 950 s−1 with decreasing separation at a bulk velocity of 3.0 m/s. Probability density functions were near Gaussian and hence much larger instantaneous strain rates were observed. The PIV image size had the advantage that it allowed the entire flow field to be viewed in terms of velocity vectors and derived quantities include mean strain rates. Small asymmetry of the flow and the higher strain rates at finite distances from the nominal impingement plane were observed. The experimental results permitted the domain of applicability of different modelling approaches to be defined more accurately and calculations were performed with different turbulence models. The results showed that two-equation turbulence models did not represent turbulence intensities close to impingement and that Reynolds stress closures produce superior agreement. It was further shown that ad hoc modifications to the dissipation equation, such as those based on the ratio of the turbulent to mean strain time scale, can improve results at the expense of generality. It is also shown that mean flows are well reproduced by a Reynolds stress closure for all nozzle separations. Comments are included on the implications of the results for investigations of reacting flows and extinction.