Vat photopolymerization of low-titanium lunar regolith simulant for optimal mechanical performance

Abstract

Recently additive manufacturing of lunar regolith to utilize in-situ resources of the Moon for deep space exploration has attracted attention. However, most previous works have been limited by low precision, inferior mechanical properties, and complex processes, such as ball grinding. Furthermore, the regional distribution difference of the lunar regolith which shows compositional diversity, demands the exploration of manufacturing of low-titanium lunar soil, which has not been comprehensively studied before. Herein, the vat photopolymerization and heat treatment of raw low-titanium lunar regolith simulant were investigated to achieve high dimensional precision and high mechanical properties. The influence of solid content and photoinitiator concentration on printability is carefully examined based on the characterization of rheological behaviors and curing depth. Then the vat photopolymerization is used to build green bodies with good interlayer bonding strength and high dimensional precision. Besides this, the effect of the debinding heating rate and sintering temperature on samples were optimized in air and nitrogen to enhance the mechanical properties of printed samples. Finally, the optimal sintered parts with a flexural strength of 108.8 MPa and compressive strength of 222.8 MPa were obtained.