Abstract

Infrared (IR) lasers are extensively utilized as an effective tool in many medical practices. Nevertheless, light penetration into the inspected tissue, which is highly affected by tissue optical properties, is a crucial factor for successful optical procedures. Although the optical properties are highly wavelength-dependent, they can be affected by the power of the incident laser. The present study demonstrates a considerable change in the scattering and absorption coefficients as a result of varying the incident laser power probing into biological samples at a constant laser wavelength (808 nm). The optical parameters were investigated using an integrating sphere and Kubelka-Munk model. Additionally, fluence distribution at the sample’s surface was modeled using COMSOL-multiphysics software. The experimental results were validated using Receiver Operating Characteristic (ROC) curves and Monte-Carlo simulation. The results showed that tissue scattering coefficient decreases as the incident laser power increases while the absorption coefficient experienced a slight change. Moreover, the penetration depth increases with the optical parameters. The reduction in the scattering coefficients leads to wider and more diffusive fluence rate distribution at the tissue surface. The simulation results showed a good agreement with the experimental data and revealed that tissue anisotropy may be responsible for this scattering reduction. The present findings could be considered in order for the specialists to accurately specify the laser optical dose in various biomedical applications.

Highlights

  • Nowadays, optical methods are widely utilized in medical diagnosis and treatment due to their high safety and functionality [1,2,3]

  • The diffuse reflectance Rd decreases at higher incident laser power

  • The absorption and reduced scattering coefficients of the skull and skin samples have been calculated at different incident laser powers

Read more

Summary

Introduction

Optical methods are widely utilized in medical diagnosis and treatment due to their high safety and functionality [1,2,3]. Light in the red to the near-infrared range is used to probe the tissue while the reflected/transmitted light is collected using detectors or CCD cameras. The captured reflected/transmitted light provide important information about tissue pathology [4]. The light reflection and transmission by the tissue are diffused in nature due to the inhomogeneity and dense scattering characteristics of biological tissue [5]. The propagation of light in the tissue is affected by the tissue absorption and scattering parameters. These parameters are wavelength-dependent and specific for each tissue type [6]. The optical dose is greatly affected by the scattering and absorption parameters of the examined tissue; an accurate calculation of these parameters is highly required.

Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.