Abstract

There is no standardized method for the sampling of greenhouse gas fluxes from soil. Two methods are primarily used: closed dynamic chamber (CDC) and closed static chamber (CSC) systems. The most complex and costly are the CDC systems, which can sample gases in situ. However, the low-cost CSC systems are being increasingly used in which the gas samples are collected manually and analyzed off-site at a later date. Given their growing popularity, it is important to optimize the sampling procedure of the CSC systems to ensure that the measurements are both repeatable and representative. Samples from a commercial potato crop were collected in the morning and afternoon at 0, 15, 30, 60, 90, and 120 min after the chambers were closed, and the concentrations of carbon dioxide (CO2), methane (CH4), and nitrous oxide (N2O) were determined using gas chromatography. The concentrations of CO2 and N2O inside chambers increased linearly over time, whereas the concentration of CH4 remained constant. The fluxes of CO2 and N2O from soil were greater in the afternoon than the morning, whereas the flux of CH4 was greater in the morning. For longer-term single-point soil flux monitoring using CSCs with a volume of 6.3 L, it is recommended that samples are collected in the morning at 0, 30, and 60 min after chambers are closed. This approach will ensure that the concentration of the gases are representative and will allow for a high level of repeatability and certainty in the results.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call