Abstract
ABSTRACT Thermal energy storage tanks are one of the widely used energy storage systems. In these systems, thermal stratification and energy storage capacity are the most important parameters affecting system performance. In this study, a porous medium was placed in the upper part of the tank, where the water in the tank is the hottest, in order to increase the system performance for standby mode. Thus, convection-induced movement of the water in the upper part of the tank was tried to be minimized and it was aimed to reduce the temperature drop. The results were determined experimentally in terms of first law and second law efficiency, maximum temperature difference, and overall heat transfer coefficient over a 48 hours cooling period. The porous media thickness was used as a parameter and its values were chosen as 10, 12, 14, and 16 cm. The best results were obtained for the porous media thickness of 16 cm, at which thermal stratification, first law, and second law efficiency increased by an average of 1.8 times, 1.6%, and 2.3%, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.