Abstract
The degree of leaflet orientation was measured for five soybean (Glycine max L., Merr.) cultivars on an hourly basis from 0620 (0700 EST) until 1820 (1900 EST) hours Local Solar Time during the 10 node stage of development (V10) and from 0520 (0700 EDT) until 1820 (2000 EDT) hours during the beginning pod stage (R3). Measurements were taken on 4 separate days during each growth stage. Our primary objective was to determine if differences exist among soybean cultivars in degree of leaflet orientation.There was significant variation among cultivars in the degree of orientation of the center and the side leaflets of trifoliolates at different times of the day.during both growth stages. The orientation of the center leaflets of a trifoliolate differed from that of the side leaflets. The vertical inclination of the center leaflets tended to change over time while the horizontal inclination remained relatively constant. On the other hand, the horizontal inclination of the side leaflets tended to change over time while their vertical orientation remained relatively constant. However, due to their location relative to each other, the different directions of movement of the center vs. side leaflets seem necessary in order for all three leaflets to attain similar exposures to incoming radiation.Maximum variation in leaf movement was noted from 0820 until 1620 hours during both V10 and R3 stages of development. Higher angles of inclination were obtained and maintained during R3 than V10.The K concentration in pulvini was significantly higher (p < 0.01) during the tense state (higher angles of leaflet orientation) than during the relaxed state. It appears that the K concentration in the pulvinus might have some role in regulating the bending and straightening movements of the pulvini, perhaps by inducing changes in turgor pressure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.