Variation in Cooper’s Hawk (Accipiter cooperii) Eggshell Thickness: DDT, Measurement Methods, and Location

Abstract

Abstract We collected Cooper’s Hawk (Accipiter cooperii) eggshells from nests in the Tucson, Arizona, USA, area in the 1990s incidental to other activities and compared them to pre-DDT Cooper’s Hawk eggshells (119 museum specimens from 14 states, 1894–1939) ranging from 0.284–0.402 mm (x̄ = 0.348 mm, SD = 0.0243) and we also compared them to reported thicknesses found in the literature. We found that within-state eggshell thickness varied as did eggshell thickness among states. Of the pre-DDT eggshells measured, those from Arizona, Utah, and Nevada were thinnest and generally eggs from western states (x̄ = 0.339 mm, SD = 0.0184) had significantly thinner eggshells than those for eastern states (x̄ = 0.359 mm, SD = 0.0256). Other published measurements of pre-DDT Cooper’s Hawk eggshells were slightly lower than ours but were generally within the lower range of our measurements, which was expected because of the measuring technique used in earlier studies versus our method. Cooper’s Hawk eggshells that were collected from nests in the Tucson area in the 1990s had a mean thickness of 0.309 mm (SD = 0.0191) and the pre-DDT mean thickness of museum eggshells from Arizona was 0.333 mm (SD = 0.018). Although the Tucson eggshells were significantly thinner than pre-DDT eggshells overall (t = 10.8, df = 100.4, P < 0.001), some individual pre-DDT eggshells and even some means from other regions (e.g., New Hampshire, New York, and Nevada) were similarly thin. Measurements of these pre-DDT eggshells show wide variation and demonstrate the importance of comparing eggs from the same geographical area and having an adequate sample size.