Variable-Target-Function and Build-up Procedures for the Calculation of Protein Conformation. Application to Bovine Pancreatic Trypsin Inhibitor Using Limited Simulated Nuclear Magnetic Resonance Data

Abstract

An implementation of the variable-target-function procedure, first introduced by Braun and Go [W. Braun and N. Go, J. Mol. Biol. 186, 611-626 (1985)], has been used to generate conformations of the small protein bovine pancreatic trypsin inhibitor (BPTI), given a limited set of simulated data that could be obtained by nuclear magnetic resonance (NMR) techniques. A hybrid strategy was also used to calculate conformations of BPTI, given the same information. In the hybrid strategy, low-energy structures of medium-size fragments (decapeptides) of BPTI were generated using the variable-target-function method, followed by restrained energy optimization. The low-energy conformations were used as a basis to build up the complete fifty-eight-residue BPTI molecule. By using the variable-target-function approach, in which energy considerations were not introduced until full conformations of the entire BPTI molecule had been generated, it was not possible to obtain calculated structures with rms deviations from the X-ray conformation of less than 1.6 A for the alpha-carbons. On the other hand, with the hybrid strategy, which involved the consideration of realistic energy terms in the early stages of the calculations, it was possible to calculate low-energy conformations of BPTI with rms deviations from the X-ray structure of 1.06 to 1.50 A for the alpha-carbons. When the rms deviations were computed along the amino acid sequence, it was found that there was a good correlation between deviations among the calculated structures and deviations from the X-ray structure.