Abstract

BackgroundAlteration of patellar height is commonly encountered in total knee arthroplasty (TKA), and failure to address patella baja can result in suboptimal functional outcomes. It may therefore be prudent to evaluate pre-operative patellar height (PPH) and to seek risk factors for patella baja.MethodsTwo hundred eighty-five patients who underwent TKA were included. Patient’s age, gender, body mass index (BMI), and history of prior arthroscopy were recorded. PPH was measured using plateau-patella angle (PPA) as well as the Blackburn-Peel (BP), Caton-Deschamps (CD), and Insall-Salvati (IS) ratios.ResultsThe average patients’ age was 71 years with a mean BMI of 30.45. There were 191 female and 94 male patients. One-fourth of the cases had at least one prior knee arthroscopy. Multivariate linear regression analysis identified gender and BMI as variables significantly affecting the IS ratio (p: < 0.05). Gender also had a significant correlation with PPA. Male patients were likely to have lower PPA (p: < 0.03). Though increasing age had a positive correlation with patellar height, this was not statistically significant. History of prior arthroscopy had no significant effect on any of the four PPH measurements.ConclusionLower patellar height is significantly correlated to male gender and high BMI. We suggest that obese male patients be screened for pre-operative patella baja. This can help in surgical planning and optimizing results in TKA.

Highlights

  • Patellar position has a great influence on knee joint biomechanics, and abnormalities in patellar height may affect patellofemoral function [1]

  • Patella baja may occur either due to true shortening of the patellar tendon or elevation of the femoro-tibial joint line [9]. This reduction of patellar height is commonly encountered in total knee arthroplasty (TKA), and failure to address it can result in suboptimal functional outcomes [10]

  • Our study confirms that pre-operative patellar height (PPH) value cut-offs for IS ratio, BP ratio, CD ratio, and plateau-patella angle (PPA) in patients undergoing primary TKA are not much different from the original reported, established baseline values for the entire population (Table 2)

Read more

Summary

Introduction

Patellar position has a great influence on knee joint biomechanics, and abnormalities in patellar height may affect patellofemoral function [1]. Patella baja may occur either due to true shortening of the patellar tendon or elevation of the femoro-tibial joint line (pseudo-patella baja) [9]. This reduction of patellar height is commonly encountered in total knee arthroplasty (TKA), and failure to address it can result in suboptimal functional outcomes [10]. Alteration of patellar height is commonly encountered in total knee arthroplasty (TKA), and failure to address patella baja can result in suboptimal functional outcomes. PPH was measured using plateau-patella angle (PPA) as well as the BlackburnPeel (BP), Caton-Deschamps (CD), and Insall-Salvati (IS) ratios. History of prior arthroscopy had no significant effect on any of the four PPH measurements

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call