Abstract

During the turning process, if the feed rate too high, or the feed rate too large, chattering will be occurred. The variable stiffness tip can change the system stiffness during the machine work, so as to increase the limit depth, but the stability of time-varying systems is difficult to predict. This article will be explained in as follows: Firstly, in this paper, the turning stiffness is studied, and the turning dynamics model is established. Secondly, it predicts the limit depth of cut by changing the time domain model parameters, and using the variable stiffness method to optimize the ultimate depth of cut. Finally, verify the correctness of the limit depth of cut through experiments.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.