Vapour shielding of liquid-metal CPS-based targets under ELM-like and disruption transient loading

Abstract

This paper presents experimental studies of plasma-surface interactions during powerful plasma impacts of a quasi-stationary plasma accelerator (QSPA) on the Sn capillary porous systems (CPSs) in conditions simulating disruption and edge localized modes (ELM) like loads. Experiments were carried out using two QSPA devices. ELM-like plasma exposures were performed with QSPA-M test-bed facility. A large-scale QSPA Kh-50 device was used to simulate plasma disruptions and giant ELMs. Variation of the plasma stream energy density has been performed to study the onset of vapour shield. It is shown that during plasma exposures of a Sn-CPS target with the QSPA plasma load <1 MJ m−2, single dust particles traces have been registered. A further increase in the heat load leads to the splashing of the eroded material. For ELM-like impacts, a rather weak melt motion was observed on the target surface. A post-mortem analysis has shown that the CPS structure was not destroyed in the course of many repetitive ELM-like pulses. Surface morphology has changed from a smooth surface to corrugation structures with the formation of some cavities in mesh cells due to the influence of the surface tension and capillary effects. Spectral lines of Sn I and Sn II have been identified by optical emission spectroscopy in the near-surface plasma. A plasma shield, that consists mostly of Sn neutrals appears at Q ∼ 0.1 MJ m−2. An increase in the surface heat load resulted in the intensive emission of Sn II lines, which started to be observed at Q ∼ 0.3 MJ m−2. The plasma electron density near the surface increases significantly at Q > 0.5 MJ m−2, which corresponds to the strong vapour shielding of the exposed surface. A comparison between the obtained results on the vapour shielding of Sn CPS and available numerical simulation using the TOKES code has been performed.